Since the invention of braided, stainless steel hose, racers and mechanics have been struggling to install it into the socket part of the AN hose assembly. If you're lucky and get a clean cut on the hose end, you might get it in. Most of the time the hose end is a bit fuzzy and the battle begins. It is not only time consuming, it can get bloody as well.
The AN Hose Assembly Tool fills a need that was long overdue. Just insert the socket into the capsule of the hose assembly tool, twist in the hose, and the assembly is complete is less than ten seconds. There's no need to worry about wear or tear. This tool is made of a high-tech composite and is virtually indestructible. You can even repeat this process several times without re-cutting this hose end.
You'll be amazed at the amount of time you save and pain you avoid by using this tool. Gone are the days of stabbing your fingers with frayed hose ends and scraping AN hose because it was cut too short. The money you save from buying band-aids alone will pay for the tool.
AN Hose Assembly Tool Details
Hot Rod Kit
* AN Hose Assembly Tool does not work with PTFE (Teflon) hose.
Installs sizes -6,-8,-10 AN hose.
Includes spacers and sleeves for different sized sockets.
All -16s (excepts Russell's brand) use the sleeve and a rear spacer.
Most -10s and -12s will use a spacer.
See the instructions in the case for the proper spacer number.
* We have additional information on our instructions page, our video page, and our shop tips for AN Hose Assembly.